The main purpose of IGK devices, which are now available even in residential use, is to give the indoor air to the outside and to take the fresh air from the outdoor environment to the interior. IGK devices achieve this goal with control cards and sensors that ensure the coordinated operation of multiple functions.
Destek Otomasyon’s own design and production CO2 sensor is the sensor used to measure the amount of CO in the air. The humidity sensor is used to measure the humidity of the air. The temperature sensor is NTC 10kΩ type, which is used in air temperature measurement. The control card can be calibrated according to these sensors. They are suitable sensors for duct-type use.
To achieve better performance in heat recovery systems and to achieve maximum savings in energy used for heating and ventilation and to provide accessories list offered in accordance with the options that vary according to the differences of the devices;
1. Temperature Sensor
NTC 10kΩ (@25°C) type is the sensor used for air temperature measurement. The control card can be calibrated according to this sensor. Suitable for duct type use.
2. Humidity Sensor
It is the sensor used for the measurement of the humidity of the air. The control card can be calibrated according to this sensor. Suitable for duct type use.
3. CO2 Sensor
It is the sensor used to measure the amount of CO2 in the air. The control card can be calibrated according to this sensor. Suitable for duct type use.
It is the sensor used to measure the amount of CO2 and moisture in the air at the same time. It is created by combining 2 sensors. The control card can be calibrated according to this sensor. Suitable for duct type use.
It is the sensor used to measure the air pressure difference. It can be used for constant flow rate, constant pressure functions and filter contamination measurement. The control card can be calibrated according to this sensor. Suitable for duct type use.
Destech HRC AC Fan Speed
Designed for AC Fan Control, the AC Speed Adjustment Board provides speed control with the trimpot located on the device. The control card is suitable for use with user interfaces. The AC speed adjustment board can be used with user interfaces without the need for a control card with fan output, fan failure, panel boost, low-mid-high functions.